Self Binding Gravel | Hoggin Path (2024)

FAQs

What are the disadvantages of self-binding gravel? ›

The Truth About Self-Binding Gravel

However, it will still become displaced after heavy use. For this reason, it will need to be spread and smoothen now and again to maintain the desired aesthetic appearance. As well as this weakness, self-binding gravel is not resistant to weeds.

In general, most of the self-binding materials can be dug out years after first being placed, crumbled and re-used (there are certain exceptions).

Proper preparation of the ground is crucial before laying self-binding gravel. This involves digging the area and laying a weed suppressant membrane to prevent unwanted growth. Spread and compact Type 1 Sub-base Scalpings to create a strong, well-draining foundation for your self-binding gravel.

It is also permeable, allowing water to drain through and reducing the risk of flooding or water damage. Additionally, self-binding gravel is a cost-effective solution that can be used in a variety of applications, from decorative garden paths to heavy-duty driveways.

Some self-binding gravel works better than other gravel types. In this case, Deansett gravel works best for car parks, driveways, running tracks, and cycle areas. It's alluring pinkish to red tone makes it a charming option for the mentioned areas.

Self-binding gravel, sometimes called “Hoggin,” is a blend of small stones, sharp sand, and clay that binds tightly when compacted, creating a solid gravel surface. It is often used in public parks and stately homes for pathways and is relatively cheap.

We recommend that a timber or suitable path edging material is used to retain the self-binding gravel. For a more natural finish, you could lay turf along the edge of the gravel to give a softer landscape finish if required.

All debris should be removed from the surface by brushing or by using a leaf blower. It is important to prevent organic matter from building up. Letting it accumulate will affect drainage and also encourage weed growth.

The naturally occurring Marl found in the product will allow the surface to become firmer over time provided the correct installation procedure has been followed. Occasional sweeping to remove leaves/detritus. Heavy deposits of mud may require scraping with shovel.

Therefore the best gravel for a path would be angular gravel chipping. There are lots of types of gravel that you can use for a path, however size wise, we suggest a chipping between 10 to 20mm. This will be large enough it won't get stuck in shoe threads and is easier to walk over.

How to make a gravel path solid? ›

Fill with gravel

Rake it out so it is evenly distributed and none of the landscape fabric shows through. Don't fill to the top of the edging. Leave about a half inch of edging above the gravel to keep it from spilling over. Use your trusty tamper or compactor to compact your top layer for a more solid walkway.

Add your gravel to a depth of approximately 25mm and rake the surface level. You should aim to leave a depth of 25mm from the gravel to the top of the edging.

Guarantees can vary between 10-20 years. When properly installed and maintained it can last up to 25 years. A Resin Bound driveway requires minimal maintenance. There are no cracks or loose stones, which helps to keep weeding and sweeping to a minimum.

A: Self-binding gravel is a natural material and will pick up on shoes, especially when the material is wet. The dusting effect will lessen with time once the material has been weathered, but a paved area or good door mat is advised before entering buildings.

The naturally occurring Marl found in the product will allow the surface to become firmer over time provided the correct installation procedure has been followed. Occasional sweeping to remove leaves/detritus. Heavy deposits of mud may require scraping with shovel.